Step 1: Strip off the finish

 

 

We believed that the bed had a wax finish on it and knew that we would need to remove it in order to apply our stain. We used Jasco Paint and Epoxy Remover. I really like this product, it has a gel like consistency and clings to the surface which is very helpful if your project is vertical. When working with a chemical stripper always wear chemical gloves (it can burn your skin). Pour the stripper into a glass or metal container (it will eat right through plastic). Brush on the stripper with a paint brush, let it sit for 15 minutes while it dissolves the finish.

 

 

Be sure to check out the video we made of this process and follow along as this bed is transformed at the end of this post!

After about 15 minutes begin to remove the dissolved finish with steel wool pads. We used a medium grit. Rub back and forth with the pad, pulling off the finish. This method works really well for surfaces that have moulding and carved details. We used this method for the entire piece. I noticed that in some of the corner areas there was still some finish to remove. I wet an old toothbrush with the stripper and worked it into the corners, then wiped the area with a paper towel. Once the entire piece is stripped, wipe down all of the surfaces with a damp cloth, removing any remaining chemicals.

Step 2: Staining the piece

 

 

We used a natural stain which we made with vinegar and a steel wool pad. Fill a glass jar with vinegar and drop in a steel wool pad. Let it sit for a day or two. The steel wool pad will pretty much dissolve.

Using a brush, paint on the vinegar mixture onto the wood. It will look clear as you first apply it and in a matter of minutes the magic happens. You get this amazing weathered wood look!

Step 3: Waxing – our final step

 

 

To achieve that great vintage, worn Restoration Hardware look we applied a white wax. We used the Behr white wax. Using a waxing brush apply the wax in a circular motion, pushing the wax into any grooves or crevices in the wood

We also wanted the wax to look a but streaky, so after the wax was applied we gently drug a chip brush (stiff and short bristled brush) across the wax, giving us the worn streaked look we were going for.

Once the wax has dried it is time to buff. I like to let it sit overnight, just to make sure the wax is all dry. Then buff, this can be done with a soft, clean cotton cloth (old t-shirt) or a buffer also works well.

Here is the finished headboard! We are thrilled with the transformation! Do you love it? For more detailed instructions please check out the original post on our site. Link down below.

Take a look at the inspiration bed from RH on the left and the finish we achieved on the right. We think it looks fantastic and this project only cost around $35. Can you believe it? That is quite a savings from the nearly $3000 bed at Restoration Hardware!

Be sure to check out the video tutorial to see this Restoration Hardware finish come to life! You can also tour the completed Master Bedroom Makeover and shop the look here!